Sleeve Puller Cold Socket 1.250"

For the racer that has purchased a cold sleeve puller from us in the past or getting ready to purchase one for this season, RBS is excited to offer this extended 1.250" 6 point deep socket for a 1/2" square drive that will make extracting sleeves out of the block a much easier task then before with a wrench.

Not for use with an air Impact gun (rattle guns). Socket is made from durable heat treated steel and will provide years of service if taken care of properly.

Socket measures 11.00" end to end and has the correct size tube for the Acme thread rod to travel up in to when pulling the sleeve out of the engine block.