SOLD Used Cragar 85mm Alum. Large Dia. Idler Pulley

Part No.: 7012-0019

Out of Stock

Categories:
Superchargers
Previously Owned
Idler Pulley
PREVIOUSLY OWNED
CRAGAR

For the racer that is doing a Cackle Fest restoration project, or possibly a engine that will be a static display, period correct speed parts can make or break the project. A new shiny billet idler pulley on a 60's or 70's motor will not cut it. So for some lucky builder we have a period correct Cragar 85mm wide large diameter idler pulley. These were the standard for idler pulleys back in the day when a racer ran 85mm rubber belts long before Kevlar belts.

This pulley measures 3.500" wide where the belt rides, its overall dia. 5.750" and uses two single row sealed ball bearings.
Mounting spindle is there but buyer will need a bolt and T-nut to make the idler pulley complete. Finish is machined cast alum.

Another interesting thing to note is Cragar would install a 1/2" spacer to get the 3.50" wide idler pulley so if you need this for a 3.00" 75mm wide application take the idler apart remove the spacer, reassemble and you now have a 3.00" 75mm idler pulley from the golden era of drag racing.

Bearings are little crunchy so if you are going to run the idler pulley you will want to replace those with two of #600-0001A bearings.

Note: This is a used item. This item might have been taken in on a trade. RBS may have inspected this item and deemed re-usable. There is no warranty expressed or implied with this item.