Outboard Brace Idler Bracket Stand Spacer

This pistol grip spacer can be used with RCD or most other Hemi idler brackets that use a outboard support brace. Made from billet alum. this spacer supports the front brace on the opposite side of the idler pulley.

Racer can choose from a 3.875" spacer for 75mm belts or 4.125" for 84mm wide blower belts.

The last pictures shows all the hardware that the pistol grip spacer uses that can be purchased at an additional cost if the racer chooses.

Spacer is set up for a .500" stud on the front and a .375" fastener on the rear.

Racer can choose pistol grip width from drop down menu.