RCD Alum. Blower Starter Frame 6.00"

Don't waste your time trying to straighten out an old steel frame or fighting getting your blower starter off the car once the motor is running. Treat yourself to this machined piece of art.

Please specify when ordering there is two different starter motor ends for the starters a 6.00" or 7.00". The easiest way to tell is measure the gear end of your starter it will be 6.00" or 7.00" or look at your starter and if there is two holes up top and two on the bottom it is a 6.00", three up top one on the bottom it is a 7.00" and last but not least measure the center hole in your frame 4.00" is a 6.00" or 4.625" is a 7.00".

These frames will not fit the big C&A or Davis starters. A new added bonus on the frame it has been machined with a foot to hold the starter from rolling around when it is not in use and sitting on a flat surface.